Stahls' Magic Mask 12x15 inch sheet medium tack heat transfer application tape to be used with pattern and printed heat transfer vinyls HTT1
Stahls' Magic Mask medium tack heat transfer vinyl application tape for patterned htv. 12x15" You do not need this for the fashion film, siser easyweed or glitter products.
Breeze Print Company offers pattern craft vinyl in any color and a huge variety of designs on multiple styles of vinyl.
Suitable for Cotton, polyester, acrylic and similar fibers.
1.Cut a piece of mask slightly wider than the image to cover.
2. Remove the paper backing from the mask and set aside.
3. Adhesive side up, place the mask down on a smooth, firm surface.
4. With the image facing down, center it over the mask letting the middle drop down
onto the adhesive, followed by the rest of the image.
5. Place your squeegee at a 45° angle over the center of the image. Using firm
pressure, push the squeegee towards the outer edge of the image. This removes
any trapped air creating a bond between the image and the mask.
6. Repeat this process in several directions.
7. Lift a corner of the mask, use a steady motion to seperate the mask from the image.
8. If not using immediately, place the transferred image back on the shiny side of the original masking paper you had set aside.
It is possible BUT NOT GUARANTEED to get 2-3 uses out of each piece. After the first use, replace used tape back on to original tape backing.
DIRECTIONS FOR HEAT PRESS-
Cut pattern/color side (not in reverse) and weed excess material.. Apply heat transfer tape to top of design (not included), squeegee, remove backing and place on garment. Heat press at 320 degrees for 18 seconds with medium to heavy pressure. Peel hot within 5 seconds.
DIRECTION FOR IRON-
***Test on scrap fabric or in an inconspicuous area first to figure out your needed time and iron settings since all irons are different.
Cut pattern/color side (not in reverse). Weed excess material. Apply heat transfer tape to the top of the design (not included), squeegee, remove backing and place on garment.
PLACE PARCHMENT PAPER OR TEFLON SHEET on top of vinyl and tape. If you do not use parchment paper or teflon, the vinyl will melt.
Turn iron onto "blend" fabric setting or medium-low to medium heat. Start with 10 seconds with even downward pressure and add an additional 5 seconds as needed. Try to avoid moving the iron. When the pattern of the fabric threads and the edges are attached, the vinyl is properly adhered.
Looking for a different size, longer length, color or pattern? Check our store and if you still can’t find it, let us know. We can make it.
We only use full color high quality EcoSolvent inks.
**Due to variations in monitors, colors may vary slightly.
Contact us for any custom orders.
Handling is usually 3-5 business days. Custom orders may take a little longer.
We do not refund for user error including but not limited to not following instructions, melting htv and using improper transfer tape. If this is the first time you are using our vinyl and/or you are using an iron to apply htv the customer needs to do a test cut and test pressing first with small or scrap pieces until the desired results are achieved. We do not recommend making a full design with the vinyl until you have familiarized yourself with it using your equipment. We include instructions in the package but if you have questions, we are always happy to help. Instructions are meant to be used as guidelines due to variations in heat presses, cutters and irons.